Pretreatment / activation of plastic surfaces

Laboratory management

Responsible employees

Corona treatment (Room A.2.19)

• This laboratory device can be used to analyse the effect of a dielectric barrier discharge (= corona) on flat plastic samples (up to DIN A4).
• Device: Softal CVE002-L-HA-1MB 

Plasma treatment (low pressure) (Room C.-1.09)

• In a large vacuum chamber, plastic surfaces are gently treated with a kHz discharge in the range of 1 - 2 kW at a pressure below 100 Pa. Two types of gas can be supplied independently of each other.
• Device: Diener Tetra 140-LF-PC 

Painting booth (Room C.-1.07)

• Paints can be mixed, tested for viscosity and sprayed on using a semi-automatic paint sprayer. A heating cabinet is available for drying. Adhesion can be analysed using cross-cut equipment. 

Tampon print (Room C.-1.08)

• Device for small series printing with manual parts feed. Vertical print stroke only. Single-colour printing with closed colour generator system. Maximum print image size Ø 75 mm
• Device: Morlock MTM 100 

Room

• A.2.19 / C.-1.07 / C.-1.08 / C.-1.09